Multiple Choice Questions On Scr (Silicon Controlled Rectifier) Part 1

Hello Engineers.

Q.1 If the current of an SCR increases, the forward breakdown voltage will

A. Decrease

B. Not be effected

C. Increase

D. Become zero

Ans: A

Q.2 If the gate current of an scr is increased, the forward breakdown voltage will

A. Increase

B. Decrease

C. Not be affected

D. Become infinite

Ans: C

Q.3 After firing an scr, the gate pulse is remove. The current in the scr will

A. Remain the same

B. Immediately fall to zero

C. Rise up

D. Rise a little and then fall to zero

Ans: A

Q.4 An scr conducts an appreciable current when the gate is negative and the a node is positive with respect to the cathode.

A. Gate is negative and the anode is positive with respect to the cathode

B. Anode and the gate are both negative with respect to the cathode

C. Anode and the gate are both positive with respect to the cathode

D. Anode is negative and the gate is positive with respect to the cathode.

Ans: C

Q.5 Pulse gate triggering is achieved by means of

A. An LC circuit

B. A UJT relaxation oscillator circuit

C. A diac-triac circuit

D. A rheostatic arrangement

Ans: B

Q.6 RC triggering is preferred over resistance triggering because

A. Provides a large value of the triggering angle

B. Provides accurate triggering

C. Causes quick triggering

D. Protects the device from getting damaged

Ans: A

Q.7 The duration of the pulse in a pulse triggering system for scrs should be at least

A. 60 us

B. 40 us

C. 20 us

D. 10 us

Ans: C

Q.8 For thyristors, pulse triggering is preferred over dc triggering because

A. The gate dissipation is low

B. The pulse system is simpler

C. The triggering signal is required for a short duration

D. Of all of the above

Ans: A

Q.9 A snubber circuit is used in the scr control circuits to overcome the effects of

A. Transients in the dc supply

B. Corona

C. Electromagnetism

D. Heating caused by the high voltage ac supply

Ans: A

Q. 10 The function of a snubber circuit connected across an scr is to

A. Suppress dv/dt

B. Increase dv/dt

C. Decrease dv/dt

D. Keep transient voltage at a constant value

Ans: A

Thanks for reading

admin

Share
Published by
admin

Recent Posts

Standby Generators and Custom Commercial Generators for Sale

Humankind has become extremely dependent on electricity, without it we can’t run the household, keep…

4 years ago

Electrical Machine Interview Question And Answer

[1] Define the term synchronous speed [Dec-2003] For synchronous machines there exists a fixed relationship…

7 years ago

Transformer Interview Questions With Answer

We shared a lot of interview questions on electrical machines, power system and power electronics. Today we…

7 years ago

What Is Diesel Power Station

DIESEL POWER STATION A generating station in which diesel engine is used as the prime…

7 years ago

Synchronous Generator Interview Questions

Q:Why syn. generators are used for the production of electricity? A:synchronous machines have capability to…

7 years ago

Hydro Power Station

Hydro-electric Power Station A generating station which utilises the potential energy of water at a…

7 years ago