A. Since the power factor of transformer is dependent on load we only define VA rating and does not include power factor .In case of motors, power factor depend on construction and hence rating of motors is in KWatts and include power factor.
A. Yes. Copper loss varies inversely with power factor.It depends on current in primary and secondary windings. It is known that current required is higher when power factor is lower
A. By laminating the core we can minimize eddy current loss.
A. Yes. It draws No load primary current.
A. Delta-delta transformer is used at generating station or a receiving station for Change of Voltage (i,e) generally it is used where the Voltage is high & Current is low whereas Delta-star is a distribution kind of transformer where from secondary star neutral is taken as a return path and this configuration is used for Step down voltage phenomena.
A. Transformer Oil serves mainly two purposes
1. It acts as liquid insulation in electrical power transformer
2. It dissipates heat of the transformer i.e acts as coolant.
In addition to these, this it serves other two other purposes, it helps to preserve the core and winding as these are fully immersed inside oil and also prevents direct contact of atmospheric oxygen with cellulose made paper insulation of windings, which is susceptible to oxidation.During 1970s, polychlorinated biphenyls (PCB)s were often used as a dielectric fluid since they are not flammable. But, They are toxic, and under incomplete combustion, can form highly toxic products such as furan.
Presently, non-toxic, stable silicon-based or fluoridated hydrocarbons are used. Combustion-resistant vegetable oil-based dielectric coolants and synthetic pentaerythritol tetra fatty acid (C7, C8) esters are also becoming increasingly common as alternatives to naphthenic mineral oil.
A. As we know the Voltage & current relation for transformer-V1/V2 = I2/I1
We Know, VI= 540 V; V2=11KV or 11000 V; I1= 2334 Amps.
By putting these value on Relation-
540/11000= I2/2334
So,I2 = 114.5 Amps
A. A variable frequency transformer is used to transmit electricity between two asynchronous alternating current domains. It is a double fed electric machine resembling a vertical shaft hydroelectric generator with a three-phase wound rotor, connected by slip rings to one external ac power circuit. A direct-current torque motor is mounted on the same shaft. Changing the direction of torque applied to the shaft changes the direction of power flow; with no applied torque, the shaft rotates due to the difference in frequency between the networks connected to the rotor and stator. Thus it acts as a continuously adjustable phase shifting transformer. It allows control of the power flow between two networks.
A. Mainly transformer has high inductance and low resistance. In case of DC supply there is no inductance, only resistance will act in the electrical circuit. So, high electrical current will flow through primary side of the transformer. Due to this the coil and insulation will burn out.
A. For lighting loads, neutral conductor is must and hence the secondary must be star winding. This lighting load is always unbalanced in all three phases. To minimize the current unbalance in the primary we use delta winding in the primary. So delta / star transformer is used for lighting loads.
A. 1. ONAN (oil natural, air natural)
2. ONAF (oil natural, air forced)
3. OFAF (oil forced, air forced)
4. ODWF (oil direct, water forced)
5. OFAN (oil forced, air forced)
Humankind has become extremely dependent on electricity, without it we can’t run the household, keep…
[1] Define the term synchronous speed [Dec-2003] For synchronous machines there exists a fixed relationship…
We shared a lot of interview questions on electrical machines, power system and power electronics. Today we…
DIESEL POWER STATION A generating station in which diesel engine is used as the prime…
Q:Why syn. generators are used for the production of electricity? A:synchronous machines have capability to…
Hydro-electric Power Station A generating station which utilises the potential energy of water at a…