[1] The reverse recovery time of the diode is defined as the time between the instant diode current becomes zero and the instant reverse recovery current decays to
(a) Zero
(b) 10% of the reverse peak current (IRM)
(c) 25% of (IRM)
(d) 15% of (IRM)
Ans: C
Ans: C
[3] The softness factor for soft-recovery and fast-recovery diodes are respectively
(a) 1, >1
(b) <1, 1
(c) 1, 1
(d) 1, <1
Ans: D
[4] Reverse recovery current in a diode depends on
(a) Forward field current
(b) Storage charge
(c) Temperature
(d) PIV
Ans:D
[7] The three terminals of MCT
(a) Anode, cathode, gate
(b) Collector, emitter, gate
(c) Drain, source, base
(d) Drain, source, gate
Ans: A
[8] Compared to Power MOSFET, the Power BJT has
(a) Lower switching losses but higher conduction loss
(b) Higher switching losses and higher conduction loss
(c) Higher switching losses but lower conduction loss
(d) Lower switching losses and lower conduction loss
Ans:C
[9] Which one of the following statement is true
(a) MOSFET has positive temperature coefficient whereas BJT has negative temperature coefficient
(b) Both MOSFET and BJT have positive temperature coefficient
(c) Both MOSFET and BJT have negative temperature coefficient
(d) MOSFET has negative temperature coefficient whereas BJT has positive temperature coefficient
Ans:A
[10] Which one of the following statement is true
(a) Both MOSFET and BJT are voltage controlled devices
(b) Both MOSFET and BJT are current controlled devices
(c) MOSFET is a voltage controlled device and BJT is current controlled device
(d) MOSFET is a current controlled device and BJT is voltage controlled device
Ans: C . MOSFET operation is controlled by gate voltage and the BJT operation is controlled by base current
[11] Practical way of getting static voltage equalization in series connected SCRs is be the use of
(a) One resistor across the string
(b) Resistors of different values across each SCR
(c) Resistors of the same value across each SCR
(d) One resistor in series with the string
OPTIONS:
1) A & D
2) A
3) C
4) B
5) None of the above options
Ans: 3
[12] For series connected SCRs, dynamic equalizing circuit consists of
(a) Resistor R and capacitor C in series but with a diode D across C
(b) Series R and D circuit but with C across R
(c) Series R and C circuit but with D across R
(d) Series C and D circuit but with R across C
OPTIONS:
1) A
2) B
3) C
4) D
5) None of the above options
Ans: 3
[13] During forward blocking of two series connected SCRs, a thyristor with
(a) High leakage impedance shares lower voltage
(b) High leakage impedance shares higher voltage
(c) Low leakage impedance shares higher voltage
(d) Low leakage impedance shares lower voltage
OPTIONS:
1) B
2) D
3) B, D
4) A, C
5) None of the above options
Ans:3
[14] Thyristors A has rated gate current of 1A and thyristor B rated gate current of 100mA
(a) A is a GTO and B is a conventional SCR
(b) B is a GTO and A is a conventional SCR
(c) A may operate as a transistor
(d) B may be operate as a transistor
OPTIONS:
1) A
2) B
3) C
4) A, C
5) B, D
Ans: 4
[15] A resistor connected across the gate and cathode of an SCR increases its
(a) dv/dt rating
(b) Holding current
(c) Noise immunity
(d) Turn-off time
OPTIONS:
1) A, C
2) A, B
3) B, C
4) A, B, C
5) D
Ans: 4
Hint for Questions 5, 6, 7:
MOSFET:
IGBT
Remember that for IGBT we can represent the terminals either Drain, Source, Gate or Collector, Emitter, Gate.
MCT:
Humankind has become extremely dependent on electricity, without it we can’t run the household, keep…
[1] Define the term synchronous speed [Dec-2003] For synchronous machines there exists a fixed relationship…
We shared a lot of interview questions on electrical machines, power system and power electronics. Today we…
DIESEL POWER STATION A generating station in which diesel engine is used as the prime…
Q:Why syn. generators are used for the production of electricity? A:synchronous machines have capability to…
Hydro-electric Power Station A generating station which utilises the potential energy of water at a…